Skip to main content
Home
datazap.me
Menu
  • FAQ
  • Donate
  • Contact
  • Create Account
  • Login
Create Account
Login
user14OWST
03/30/2020
Fuel Trims
Removed CPE MAPTap, routed Tial QRJ reference hose to Sound Symposer delete for boost reference. Removed Intake Manifold to inspect and tighten Catch can hoses and connections. Then adjusted cold side charge pipe to have a better connection to silicone 90* elbow to intercooler.
  • 93 Octane
03/30/2020
Options
  • View
03/28/2020
14 ST LTFT concern
Levels intercooler, CPE Exhale cold side kit paired with Tial QRJ(Blue Spring) boost reference is from Symposer delete, Catless Downpipe, Mishimoto Intake, Damond motorsports Manifold Catch Can, Ford Racing exhaust, NGK Step Colder Plugs, CPE Trans Mount, Cobb RMM, New OEM psmm, using Castrol full synthetic 0w-40 oil. Car exhibits poor mileage(Roughly 180-200 miles to the tank, normal is 250-285 miles to the tank), minor sluggishness from a stop, unable to hit target boost of 23psi, power seems down, STFT at idle(warm) is 0%(+-1%), LTFT at idle(warm) is +10.6% and doesnt move. Will move up or down +-4% during normal driving. Upon Cold start the cars STFT and LTFT will both be at -10%, then once I begin driving STFT will be around 0% and LTFT will stay around +10%. Not sure if this is normal or not, or if I have a possible vacuum leak, exhaust leak, boost leak.
  • 93 Octane
03/28/2020
Options
  • View
12/14/2019
New Solenoid 4th gear WOT pull
  • 93 Octane
12/14/2019
Options
  • View
12/11/2019
Replaced WG Solenoid Valve.
Replaced WG Solenoid Valve or "3 port ECBS" with a known working OEM Ford Replacement.
12/11/2019
Options
  • View
12/09/2019
Same issue new logs
Persisting issue new, 3mm silicone hoses for the 2 lines off the BPV Solenoid(unable to route a new line for the vacuum pump due to both ends being different sizes.) New 3mm silicone hoses for the Wastegate Solenoid. Verified connections going from WG Solenoid to compressor housing, to WGA, To turbo inlet. Verified Wastegate Actuator by running a 3mm silicone hose from the canister on the WGA to an air compressor with the regulator set to 8psi(as low as it would go) then slowly applied pressure to the line/WGA and watched the rod move with ease open and when releasing pressure, WGA would snap shut, like it is supposed too.
12/09/2019
Options
  • View
  • ‹
  • …
  • 3
  • 4
  • 5
  • …
  • ›
  • datazap.me  
  • Login
  • Create Account
  • FAQ
  • Donate
  • Contact