 Same as before, vacuum hose plugged back in.Same set-up as previously recorded, this time with wastegate hose plugged back in.
|
11/23/2024
|
|
Wastegate set to maximum resistance at closer Pre-loaded the wastegate fully, closed the wastegate flap, and tightened with a couple turns of pre-load tension. Then actuator vacuum hose unplugged for logs. Vacuum reading was about 8.5-9inhg at full closer. Vehicle feeds about 10” at idle.
|
11/23/2024
|
Wastegate adjusted to 8inhg
|
11/23/2024
|
|
Wastegate Vacuum Hose Plugged In Flashed back to stage 0
Flashed back to V1
Wastegate Actuator Tested & Working
Wastegate Closes at 6inhg
Boost Solenoid Bench Tested & Working
Boost Solenoid Properly Plumbed
(Vacuum intake rear, vacuum supply front)
|
11/20/2024
|
|
3rd Gear / 4th Gear Pulls. WG UNPLUGGED AND OPEN Flashed back to stage 0
Flashed back to V1
Wastegate Actuator Tested & Working
Wastegate Closes at 6inhg
Boost Solenoid Bench Tested & Working
Boost Solenoid Properly Plumbed
(Vacuum intake rear, vacuum supply front)
|
11/20/2024
|