 2022-10-30 17_58_43 IJE0S IJE0S+ 17T 3.5 v4 - WBAUC73568VF25247_FFFound the issue on cyl 6. Calibration was off by value of 2 (last digit the first number, had a 6 instead of an 8). After a couple passes, got the tires hot enough to stick finally in 3rd. Felt awesome! But looks like a lot of knocking on cly 5 still. This cyl has always been noisy though. I've bored scoped it and piston looks same as the rest (no chewing/detonation pits), replaced injector seals, swapped injectors, plugs, coils etc. on it several times. Only thing I can find is this injector always feels the easiest to remove the injector when i pull it? Is the head injector hole egged out? But never saw any carbon past the seal when i pull out the injector, so I thought it was still sealing OK?
|
10/30/2022
|
|
2022-10-29 17_58_12 IJE0S IJE0S+ 17T 3.5 v4 - WBAUC73568VF25247 Regapped 1 step colder plugs to 0.18 (was 0.20). New plug installed in cyl 6. Swapped coil 6 and 4. Ony hwy pull in 3rd to 4th shift after oil was warm, still misfired on cly6. Lots of knocking on cly 5 also. Also found "super knocking" fault on cly 4 after pull? This sounds really bad.
|
10/29/2022
|
|
2022-10-28 12_52_21 IJE0S IJE0S+ 17T 3.5 v4 - WBAUC73568VF25247_FF 2022-10-28 12_41_04 IJE0S IJE0S+ 17T 3.5 v4 - WBAUC73568VF25247_FF.mhd ---- Got sideways on this into oncoming traffic almost in. 3rd gear No faults.
2022-10-28 12_52_21 IJE0S IJE0S+ 17T 3.5 v4 - WBAUC73568VF25247_FF.mhd --- 30ft of spinning in 3rd gear on launch. Cyl6 misfire found after pull, lean Bank 2 at idle until cleared fault and then OK.
|
10/28/2022
|
|
2022-10-26 19_29_55 IJE0S IJE0S+ 17T 3.5 v3 - WBAUC73568VF25247_FF.mhd Stong pull, felt quick and smooth. One thing I don't understand still is why with throttle smashed, TRAC fully OFF, why does throttle go to 50% mid pull without any knock or anything?
|
10/26/2022
|
2022-10-25 18_55_26 IJE0S IJE0S+ 17T 3.5 v2 - WBAUC73568VF25247_FF.mhd
|
10/25/2022
|