 Version 5Something is still wrong, I could not get it to replicate the smoking issue but something is off related to the tune. I am out of time tonight But I want to say if I switched to the pump gas tune it would act right, or it could be this bad ethanol I got. I had my low fuel light on for a while when I put 12 gal of "e85" in it only to come to e65 so something doesnt add up especially when 93 pump here is between 12-16% ethanol. I am not sure. Cyl 4 misfire stopped the run short. I think I attached a 2nd gear and 3rd gear (which ended in misfire) not as dramatic as last nights misfire which was "multiple cylinders (4 and 5 included)"
|
01/17/2023
|
|
Version 4 Must have had some 93 left in the tank becasue it was reading just below E70. BUT.... the smoking issue. its intermittent and only at like stop lights or idle. however when I got on it for a log it was acting strange and then at high rpm it started missing like crazy and cut boost threw the SES light. Where should I look first? Valve cover, pcv? god forbid the brand new turbos are bad? something not turbo related I hope is causing the issue. What can you see from the logs? (videos of issues in your inbox as well)
|
01/16/2023
|
|
Version 4 (Installed MOTIV Fuel Pressure sensor, Aux Fuel Pressure reading good now) Felt strong as usual. Accidentally did a 2nd gear pass I threw that in here also just because. There should be a good 3rd gear pass also. Let me know if you still want a pull without aux fuel pressure and with fuel mode recorded or if this fueling setup fixes the issues you saw. Thanks Ken
|
01/07/2023
|
|
Version 3 Super strong pull feels great very steady boost comes in just right. Had to let off a little ahead of 7000 to start braking. Felt like a slingshot (my sons tooth fell out during the pull)
|
01/05/2023
|
|
Version 2 Fixed reflex+ issue, still diagnosing 111psi issue. If you cant go any further until that is fixed I understand. Just wanted to get you the data from me testing that everything was good. I would lean towards the Aux pin out wiring being backwards as well. Will work with motiv to get a picture of what it should look like.
|
01/03/2023
|